COPYRIGHT © 2008 MERIT ENTERTAINMENT
FIGURE 8 - HARD DRIVE MOUNTING PLATE ATTACHED TO CPU SHELF
SCREW SECURING
HARD DRIVE
MOUNTING PLATE
TO THE GAME
SCREW SECURING
HARD DRIVE TO
MOUNTING PLATE
(4 PLACES)
Force Upright without Coin Door
Hard Drive Removal
1.
If you are connected to TournaMAXX
or TournaCHAMP, you must perform an
Update From Server
before remov-
ing the hard drive so that no informa-
tion is deleted.
2.
Turn off and unplug the game.
3.
Unlock and open the front bezel.
4.
Slide the CPU shelf into its service po-
sition to access the hard drive.
5.
Remove the screw securing the hard
drive mounting plate to the shelf (see
Figure 8).
6.
Remove the 4 screws and shoulder
washers fastening the hard drive to
the mounting plate. See Figure 8.
7.
Disconnect the hard drive ribbon cable
and the hard drive power connector
from the hard drive.
Hard Drive Installation
8.
Fasten the new hard drive assembly
to the existing mounting plate with the
4 screws and shoulder washers. See
Figure 1.
9.
Connect the 4-pin power connector in
the game to the mating 4-pin connector
attached to the hard drive adapter. See
Figure 1.
10. Carefully reconnect the ribbon cable in
the game to the new hard drive as
shown in Figure 1. The red stripe on
the cable should be on the opposite
side as the power connector. You may
need to create extra slack in the cable
in order to connect it.
11. Fasten the hard drive assembly to the
CPU shelf with the mounting screw
(see Figure 8).
12. Continue with
Security Key Installa-
tion
if you are installing a security key.
13. Slide the CPU shelf back into the game.
14. Close and lock the front bezel.
15. Plug in and turn on the game. The game
will reboot twice to configure the hard-
ware. When prompted, perform a
touchscreen calibration.
16. If you are connected to TournaMAXX
or TournaCHAMP, you must re-enter the
dial-in settings, make the initial call into
the server and then perform two
Up-
dates From Server
. Refer to the
MegaNet® manual for information.
PM0513-13 MEGATOUCH FORCE 2009 EDITION 8
