COPYRIGHT © 2002 MERIT INDUSTRIES, INC.
14. Replace the monitor assembly, aligning
it with the support brackets inside the
game and making sure the LCD clips fit
properly into the slots at the top of each
side. See Figure 9.
15. Tighten the nuts securing the (2) LCD
clips. See Figure 9.
16. Replace the top cover and secure it
with the (3) screws at the top of each
side piece. The shorter screw will go
in the screw hole closest to the rear of
the game. See Figure 9.
17. Connect the touchscreen controller
cable in the back of the touchscreen
controller and secure the controller on
the mounting screws in the game with
the existing hardware. Also reconnect
the molex connector connecting the
orange and gray wires to the main
power harness.
18. Replace both side panels.
19. Reconnect the monitor power connec-
tor to the power supply.
20. Route the monitor signal cable through
the cable clamps and reconnect it to
the motherboard. See Figure 3 for lo-
cation.
21. Plug in and turn on the game.
22. Use the SETUP and CALIBRATE but-
tons and the monitor control board to
adjust the monitor settings, if neces-
sary.
23. Close and lock the rear door.
FORCE RADION
NOTE: When replacing the monitor
chassis board in Megatouch FORCE
Radion games, you will need to remove
the chassis board from the metal
mounting tray before returning the
chassis board, as the replacement chas-
sis board will not include a mounting
tray.
To replace the monitor chassis board in your
Megatouch FORCE Radion game:
Monitor Chassis Board Removal
NOTE: Be extremely careful of the pic-
ture tube and monitor adjustment con-
trols.
1.
Turn off the game and unplug it
from its power source.
2.
Unlock and open both side doors and
the rear door.
3.
Remove the screw securing the strain
relief cord to the rear door, then re-
move the monitor control board from
the velcro on the rear door.
4.
Remove the screws holding the rear
bezel to the game. Five (5) screws
are located along the top edge of the
game and (2) are at the bottom rear of
each side of the game. See Figure 11.
5.
Lift the rear bezel from the game.
6.
Disconnect the hard drive ribbon cable
from the motherboard (See Figure 3).
Then remove the (3) screws securing
the hard drive mounting bracket to the
game (See Figure 12) and remove the
hard drive assembly.
7.
Using Figure 3, disconnect the follow-
ing connections on the motherboard:
•
monitor signal cable
•
touchscreen controller connector
•
Ethernet cable
•
I/O board connector
•
motherboard power connector
•
audio board connector
•
centronics connector
PM0337-01 Rev C MONITOR CHASSIS BOARD REPLACEMENT 4
