COPYRIGHT © 2002 MERIT INDUSTRIES, INC.
35. Close and lock the hood.
36. Replace and lock the coin box or coin
box/bill acceptor assembly.
FORCE ELITE
NOTE: Megatouch FORCE Elite games
will not have a monitor chassis board
and will instead have an analog to digi-
tal board on the reverse side of the dis-
play screen.
To replace the analog to digital board in your
Megatouch FORCE Elite game:
Analog to Digital Board Removal
1.
Turn off the game and unplug it
from its power source.
2.
Unlock and open the rear door.
3.
Disconnect the monitor power connec-
tion running to the power supply.
4.
Disconnect the monitor signal cable
from the motherboard and remove it
from the cable clamps. See Figure 3.
5.
Inside the game, access the latches
for each side panel and remove both
panels (see Figure 8).
6.
Remove the two nuts and washers
securing the touchscreen controller to
the game and remove the controller
from the mounting screws. Then dis-
connect the cable from the back of the
controller and disconnect the Molex
connector connecting the orange and
gray wires (from the touchscreen con-
troller cable) to the main power har-
ness.
7.
Remove the (3) screws at the top of
each side piece fastening the top cover
to the game (see Figure 9) and remove
the top cover.
8.
Loosen the 5/16” nuts securing the (2)
LCD clips (one on each side piece).
See Figure 9.
9.
Lift the bezel and monitor assembly from
the game.
10. Locate the analog to digital board on
the reverse side of the LCD display
screen. Using Figure 10, disconnect
the following connections on the board:
•
monitor signal cable (from J9).
NOTE: Leave the ground wire attached.
•
LCD connector (from J7)
•
signal and power connector (from J3)
•
on-screen display connector (from J4)
•
DC power connector (from J1)
11. Remove the (4) screws fastening the
analog to digital board to the bezel (see
Figure 10) and remove the board.
Analog to Digital Board
Replacement
12. Align the new analog to digital board
on the bezel with the monitor connec-
tor furthest from the top edge of the
bezel. Then replace the (4) screws
removed in the last step. Be sure to
reattach the ground wire from the moni-
tor signal cable (see Figure 10).
13. Using Figure 10, reconnect the follow-
ing connections on the board:
•
DC power connector (to J1)
•
signal and power connector (to J3)
•
on-screen display connector (to J4)
•
LCD connector (to J7)
•
monitor signal cable (to J9)
3 MONITOR CHASSIS BOARD REPLACEMENT PM0337-01 Rev C
