Radio Controls
Manufactured under 1 or more of the following U.S. patents:
RE29,525; 4,037,201; 4,750,118; 4,806,930. Other
Patents Pending.
CHILDREN OPERATING OR PLAYING
WITH A GARAGE DOOR OPENER CAN
INJURE THEMSELVES OR OTHERS.
THE
GARAGE DOOR COULD CLOSE AND CAUSE
SERIOUS INJURY OR DEATH.
DO NOT ALLOW
CHILDREN TO OPERATE THE DOOR CONTROL(S)
OR REMOTE CONTROL TRANSMITTER(S).
A MOVING GARAGE DOOR COULD INJURE OR
KILL SOMEONE UNDER IT.
ACTIVATE THE
OPENER ONLY WHEN YOU CAN SEE THE DOOR
CLEARLY, IT IS FREE OF OBSTRUCTIONS, AND IS
PROPERLY ADJUSTED.
23
Multi-Function
Remote Control
Select a Remote
Push Button
Green Battery
Indicator Light
Garage Door Opener
(With Green "Smart" Button)
Green
"Smart"
Button
Indicator
Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Code programming instructions are also located
on the opener panel.
Figure 1
Figure 2
Your garage door opener receiver and remote
control transmitter have been set at the factory to a
matching code. Models having multi-function remote
controls will activate when LARGE button on
remote(s) is pressed.
Below are instructions for programming your opener
to match the other buttons on your multi-function
remote and any additional remotes you may
purchase. See available accessories on page 5.
Your "Smart" garage door opener will operate with
up to four "Smart" remote controls (with green
indicator lights), a Keyless Entry System and code
switch remote controls with red indicator lights.
To Add A Remote Control
With a multi-function remote, select a push button to
operate the receiver. See Figure 1.
1. Press and
hold
the remote push button.
2. Then press and release the green "Smart" button
on the back panel of the opener in Figure 2. The
opener light(s) will
flash once.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener light(s) flash(es), the opener
has not accepted the code.
To Change the Selected
Push Button on the Same Remote Control
If you decide to use a different remote control button
than originally programmed into the opener, you
need to erase
all
the learned codes and reprogram
each remote used to operate the garage door
opener.
To Erase All Remote Control Codes
• Press and hold the green "Smart" button on the
opener panel until the indicator light turns off
(about 6 seconds).
All
the codes the opener has
learned will be erased.
• To reprogram, repeat Steps 1 and 2 for each
remote control in use.