Page
12
of
14
Step 14
(T836 & T842 Only)
When assembling a T836 & T842 “X” bracing is required on the lift arms. Attach the bracing to the lift arms
using (5) 3/8” x 1” hex flange bolts & flange nuts. Cross the braces as shown in fig. 14.1.
Step 15
(Lift Cable Assembly)
Next, attach the lift cable to the winch by sticking one end through the side of the drum and fastening the cable
to the outside of the drum. For more information refer to winch manual included with auger. Route the cable
up around the lift roller (Fig. 15.2) going from the bottom around the top. Next, pull the cable to the bottom of
the discharge tube at wrap cable around the cable stop (30993) as shown if Fig. 15.3. Secure cable around the
Fig. 13.1
Fig. 13.2
Fig. 14.1
