After Maintenance is completed, replace and secure all safety shields, safety
devices, service doors and cleanout covers.
See section 5, “Hydraulics” for information on maintenance of hydraulic hoses.
See section 7, “Appendix & Forms” for expanded lube information.
Truss Cables:
Replace cables if frayed or damaged. Be sure clamps are secure.
Adjust cables as needed to keep the auger tube reasonably straight.
Wheel Hubs:
Repack hubs every two to three years to lengthen the life of the
hubs.
Tire Pressure:
Check tire pressure monthly. The recommended tire pressure
should be maintained at 40 to 45 psi.
PTO Driveline:
Lubricate both universal joints after every eight hours of
operation. Lubricate the center portion of the driveline on a yearly basis. The
first lube maintenance should be done in the first 16 to 24 hours of operation.
Then follow a regular schedule of lubing.
Lube Recommendation:
Lube cross and bearing every 8 hours of use. Lube
telescoping members yearly.
NOTICE:
Replacement parts are not lubricated. When you receive these parts in,
make sure to lubricate and tighten screws.
Mechanical Chain Drive:
Keep drive chain tension adjusted to about
¼
”
deflection by loosening the four bolts on the lower bearing, then retightening.
Oil the chain frequently enough to keep a film of oil on the chain. This must be
done through the maintenance portal. Replace shield after maintenance.
Universal Joint:
Remove PTO guard cover and lubricate grease fitting in the U-
Joint every eight hours of use. Check PTO retain bolt and retighten if necessary.
18
