Mercury VesselView Mobile, Manual

Page: 69 / 115

Section 4 - Main Menu
90-8M0070299
eng
MAY 2012 Page 65
3. Press the down arrow on the arrow pad to proceed to the "FUEL FLOW" option.
4. Press the left or right arrow on the arrow pad to select fuel flow units of "GPH," "LPH," "MPG," "KPL," or "NMPG."
5. Once you have finished selecting your units of measure, press the check button to save the session.
NOTE: After any change or customization to the VesselView configuration, a blue pop‑up message will appear as a reminder to
save the session. It is recommended that all session changes be saved before holding the "
X
" button while keying all engines
off. Refer to
Section 1
‑
Saving the Settings
.
Offsets
The "OFFSETS" screen enables you to change the offsets in order to compensate for inaccuracies in depth, fuel, sea
temperature and steering position. The menu path is: "Main" > "Settings" > "Offsets." Press the check button to open the
"OFFSETS" screen.
a - Depth offset
b - Fuel offset
c - Sea temp offset
d - Steering offset
1. Upon entering the "OFFSETS" screen, the "DEPTH OFFSET" option will be highlighted in blue.
2. The depth offset default setting is 0.0 ft. Press the left or right arrow on the arrow pad to add or subtract depth offset. To
set an offset below the transducer, subtract from the depth offset. To set an offset above the transducer, add to the depth
offset.
a - Depth transducer
b - To set an offset below the
transducer, subtract from the depth
offset
c - No offset. Distance from depth
transducer to bottom.
d - To set an offset above the
transducer, add to the depth offset
3. Press the down arrow on the arrow pad to proceed to the "FUEL OFFSET" option.
4. The fuel offset default setting is 0.00%. Press the left or right arrow on the arrow pad to add or subtract fuel offset. If the
fuel tank does not read "0" when empty, add fuel offset until it equals the incorrect amount shown remaining in the tank.
This should change the fuel level screen so it reads "0."
NOTE: The fuel offset can only be a positive offset.
5. Press the down arrow on the arrow pad to proceed to the "SEA TEMP OFFSET" option.
6. The sea temperature default setting is 0 degrees. Take the actual seawater temperature and subtract the displayed sea
temperature. Then add or subtract the difference in temperature in the "SEA TEMP OFFSET" option using the left or right
arrow on the arrow pad.
7. Press the down arrow on the arrow pad to proceed to the "STEERING OFFSET" option.
8. Use the left or right arrow button to adjust the steering position in either direction.
9. After making changes to the offsets, press the check button to save the session.
45165
STEERING OFFSET
0
O
a
b
c
d
FUEL OFFSET
0.00 %
32883
b
c
d
a