Mercury VesselView Mobile, Manual

Page: 60 / 115

Section 4 - Main Menu
Page 56 90-8M0070299
eng
MAY 2012
Status Bar Options
The status bar is located at the top of the screen and is separated in three different data options. Changes to the status bar are
made in the "STATUS BAR" screen. The menu path is: "Main" > "Settings" > "Screen Options" > "Status Bar." Press the check
button to open the "STATUS BAR" screen.
a - Left data
b - Center data
c - Right data
1. The "STATUS BAR" screen will open with the "LEFT DATA" option highlighted in blue.
2. Press the left or right arrow on the arrow pad to scroll through the available display data. The data available to display is:
• "TIME"—Clock
• "SPEED"—Vessel speed (default)
• "SPD OVR GRD"—Speed over ground (GPS)
• "SEA TEMP"—Seawater temperature
• "GEAR"—Shift position
• "FUEL USAGE"—Fuel used
• "FUEL LEVEL"—Fuel tank level
• "DEPTH"—Water depth
• "CRS OVR GND"—Course over ground
(GPS)
• "BRNG TO WP"—Bearing to waypoint (GPS)
• "AIR TEMP"—Air temperature
• "STBD TAB"—Starboard tab position
• "PORT TAB"—Port tab position
• "STBD TRIM"—Starboard trim position
• "PORT TRIM"—Port trim position
• "SC TRIM"—Starboard center trim position
• "PC TRIM"—Port center trim position
• "VOLTS"—Battery voltage
3. Press the down arrow on the arrow pad to proceed to the "CENTER DATA" option.
4. Press the left or right arrow on the arrow pad to scroll through the available display data.
5. Press the down arrow on the arrow pad to proceed to the "RIGHT DATA" option.
6. Press the left or right arrow on the arrow pad to scroll through the available display data.
7. Once you have selected the status bar display data, press the check button to save the session.
NOTE: After any change or customization to the VesselView configuration, a blue pop‑up message will appear as a reminder to
save the session. It is recommended that all session changes be saved before holding the "
X
" button while keying all engines
off. Refer to
Section 1
‑
Saving the Settings
.
Steering Options
The "STEERING" screen enables you to set the display data in the vessel screen "STEERING POSITION." Refer to
Section 6
‑
Vessel Menu
. The menu path is: "Main" > "Settings" > "Screen Options" > "Steering." Press the check button to open the
"STEERING" screen.
1. Use the left or right arrow to scroll through the options in the "LEFT DATA AREA" option. Choose which information to
display in the option appearing on the bottom left of the "STEERING POSITION" screen. The available options are:
• "BOAT SPEED"—Vessel speed
• "WATER DEPTH"—Water depth
• "GEAR POS"—Gear position
• "COG"—Course over ground
a
b c
a
b
c
27132