Mercury VesselView Mobile, Manual

Page: 14 / 115

Section 2 - Setup and Calibration
Page 10 90-8M0070299
eng
MAY 2012
4. Press the check button to import the saved configuration.
IMPORT CONFIG
TO IMPORT CONFIGURATION, INSERT
MEMORY STICK AND WAIT FOR INSTRUCTIONS .
MEMORY STICK READY
TO IMPORT
27309
5. VesselView will restart and import the configuration.
NOTE: If the imported configuration settings are correct for your power package, the setup process is completed. Continue to
finalize the setup of VesselView. Refer to
Calibration Menu Options
.
Engine Setup
VesselView automatically detects the vessel's power package. On the "ENGINE SETUP" screen, you can change the type and
number of engines. The available power packages are:
• "2 Stroke Gas Outboard"
• "4 Stroke Gas Outboard"
• "Gas Sterndrive No Troll"
• "Gas Inboard No Troll"
• "Gas Jet Drive"
• "Gas Sterndrive"
• "Gas Inboard"
• "Gas Verado"
• "Diesel Sterndrive No Troll"
• "Diesel Inboard No Troll"
• "Diesel Sterndrive"
• "Diesel Inboard"
IMPORTANT: If a "Diesel Inboard No Troll" is the identified, VesselView assumes the installed power package is a Zeus drive
and will turn on the AutoPilot screens; Pilot, Joystick, Skyhook. All other drive types, the pilot screens must be turned on or off
in the "Settings" option menu.
NOTE: VesselView will always default to four engines during the initial setup and after a factory reset.
a - Engine type
b - Number of engines
b
a
34503
4