Mercury TDI 4.2L, Manual

Page: 76 / 89

Section 5 - Storage
Page 70 90-8M0114081
eng
DECEMBER 2015
3. Read all precautions and perform all procedures found in
Seasonal Storage Instructions
.
4. Remove the seawater pump impeller and store away from direct sunlight. See a Mercury Diesel–authorized repair facility
for additional information and service.
IMPORTANT: The seawater pump impeller material can be damaged by prolonged exposure to direct sunlight.
5. Place a caution tag at the instrument panel and in the engine compartment stating that the seawater pump is out and not to
operate the engine.
Battery Storage
Whenever the battery will be stored for an extended period of time, be sure the cells are full of water and the battery is fully
charged and in good operating condition. It should be clean and free of leaks. Follow the battery manufacturer's instructions for
storage.
Recommissioning the Power Package
1. Ensure that all cooling system hoses are connected properly and the hose clamps are tight.
!
CAUTION
Disconnecting or connecting the battery cables in the incorrect order can cause injury from electrical shock or can damage
the electrical system. Always disconnect the negative (‑) battery cable first and connect it last.
2. Install a fully charged battery. Clean the battery cable clamps and terminals and reconnect the cables. Tighten each cable
clamp securely when connecting.
3. Coat the terminal connections with a battery terminal anticorrosion agent.
4. Perform all the checks in the
Before Starting
column of the
Operation Chart
.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
5. Start the engine and closely observe instrumentation to ensure that all systems are functioning correctly.
6. Carefully inspect the engine for fuel, oil, fluid, water, and exhaust leaks.
7. Inspect the steering system, shift and throttle control for proper operation.