Mercury Sterndrive QSD 2.0, Manual

Page: 111 / 131

Section 5 - Maintenance
90-8M0069751
eng
APRIL 2012 Page 103
3. Torque the propeller nut.
Typical Bravo One models
a - Propeller shaft splines
b - Forward thrust hub
c - Flo‑Torque II drive hub
d - Propeller
e - Drive sleeve adapter
f - Tab washer
g - Propeller nut
NOTE: The propeller torque stated is a minimum torque value.
Description Nm lb–in. lb–ft
Bravo One propeller nut
75 – 55
Then align tabs with grooves
4.
Models equipped with the tab washer
: Continue to tighten the propeller nut until the three tabs on the tab washer align
with the grooves on the spline washer.
5. Bend the three tabs down into the grooves.
a - Prop
b - Tab washer
c - Drive sleeve adapter
d - Tab bent down
e - Propeller nut
Bravo Two Models
IMPORTANT: Use the correct rotation propeller. The propeller rotation MUST match the direction of rotation of the propeller
shaft.
1. Liberally coat the propeller shaft spline with one of the following Quicksilver lubricants.
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101 Propeller shaft splines 92-802865Q02
95
2-4-C Marine Lubricant
with PTFE
Propeller shaft splines 92-802859A 1
94
Anti-Corrosion Grease Propeller shaft splines 92-802867Q 1
NOTE: Anti‑corrosion grease is for saltwater applications only.
2. Install the propeller with the attaching hardware as shown.
a
b
c
d
e
g
f
5301
a
b
c
d
e
4750