COLD WEATHER OR EXTENDED STORAGE
125
1. Remove the plug from the water separating filter/fuel pressure
regulator housing as shown and install a 1/8 in. NPT barbed
fitting (obtain locally) into the housing.
b
c
10308
a
a -
Water separating filter/fuel pressure regulator housing
b -
Plug
c -
1/8 in. NPT barbed fitting
2. Attach an outboard type portable fuel tank with primer bulb to
the barbed fitting with a hose clamp.
3. Squeeze the primer bulb until the bulb becomes firm.
NOTE: Do not turn the key switch to the "START" position during
the following priming procedure.
4. Cycle the ignition key switch to the "RUN" position for three
seconds and then "OFF."
5. Repeat steps 3 and 4, one or two more times. The object of
this procedure is to prime the fuel system but not to the point
of having the system completely full and the primer bulb hard
and under pressure.
6. With the primer bulb soft, remove the remote fuel line and
fitting from the water separating fuel filter.
Summary of Contents for Racing Sterndrive 600SCi
Page 6: ...vi ...
Page 54: ...OPERATION 44 1 7 3 5 4 6 2 1 4 2 3 6 4 2 8 6 7820 3 7 ...
Page 61: ...OPERATION 51 ...
