OPERATION
96
6. Ignition key starting - Turn the ignition key to "START" position
and release the key. The electronic starting system will
automatically crank the engine for starting. If the engine fails
to start, the engine will stop cranking. Turn the key to "START"
position again until engine starts.
ST
A
R
T
OF
F ACC ON
ST
AR
T
OF
F A
CC ON
3485
7. After engine starts, check for a steady stream of water flowing
out of the water pump indicator hole.
IMPORTANT: If no water is coming out of the water pump
indicator hole, stop engine and check the cooling water intake for
obstruction. No obstruction may indicate a water pump failure or
blockage in the cooling system. These conditions will cause the
engine to overheat. Have the outboard checked by your dealer.
Operating the engine while overheated will cause engine damage.
Gear Shifting
DTS PANEL MOUNT REMOTE CONTROL
IMPORTANT: Never shift outboard into gear unless engine speed
is at idle. Do not shift outboard into forward or reverse when the
engine is not running.
•
The outboard has three gear shift positions to provide
operation. Forward (F), Neutral (N) and Reverse (R).
3427
F
N
R
Summary of Contents for 200 VERADO
Page 4: ...iv ...
