Mercury Security © 2017
MS-ICS
DOC 10107-0053
REV 1.02
Page 5
10. Specifications:
** The interface is for use in low voltage, Class 2 Circuits only.
The installation of this device must comply with all local fire and electronic codes.
Primary power:
12 Vdc ± 10%, 275 mA maximum
Memory and
Clock Backup:
3 Volt Lithium, type BR2325, BR2330, or CR2330
Ports:
TB2
2-wire RS-485: 9,600 to 115,200 bps, asynchronous
Inputs:
3 non-supervised, dedicated for cabinet tamper, low UPS battery and UPS power fault
monitoring
Cable requirements:
Power:
1 twisted pair, 18 AWG
Ethernet:
Cat 5 minimum
RS-485:
1 twisted pair with drain wire and shield, 120 ohm impedance, 24 AWG, 4,000 ft.
(1,219 m) maximum
Environmental:
Temperature:
-55 to +85 °C, storage
0 to +50 °C, operating
Humidity:
5 to 95 % RHNC
Mechanical:
Dimension:
5.8 in. (148 mm) W x 8.6 in. (218 mm) L x 1 in. (25 mm) H
Weight:
5.7 oz. (162 g) nominal, w/o terminal blocks
Lantronix MICRO125 support:
Lantronix part number: MO11AA003-01R or equivalent
Standoff size: diameter .125 inch x 7/16 inch long. Richco, Inc. part number LMSP-7-01, 3 pieces
(not supplied)
These specifications are subject to change without notice.
Warranty
Mercury Security warrants the product is free from defects in material and workmanship under normal use and
service with proper maintenance for one year from the date of factory shipment. Mercury Security assumes no
responsibility for products damaged by improper handling or installation. This warranty is limited to the repair
or replacement of the defective unit.
There are no expressed warranties other than set forth herein. Mercury Security does not make, nor intends,
nor does it authorize any agent or representative to make any other warranties, or implied warranties, and
expressly excludes and disclaims all implied warranties of merchantability or fitness for a particular purpose.
Returns must be accompanied by a Return Material Authorization (RMA) number obtained from customer
service, and prepaid postage and insurance.
Liability
The Interface should only be used to control exits from areas where an alternative method for exit is available.
This product is not intended for, nor is rated for operation in life-critical control applications. Mercury Security
is not liable under any circumstances for loss or damage caused by or partially caused by the misapplication or
malfunction of the product. Mercury Security's liability does not extend beyond the purchase price of the
product.
