14
14
14
28
19
P 8
Please retain product label and instructions for future reference
Step 10
Parts needed - No. 14 QTY 72
Place the first two roof board’s
(
No. 14
) onto the assembly on each
side, making sure the boards are flush
to the end of the roof purlin. Once in
position fix to each purlin using
3x40mm screws.
Due to natural occurences of wood
shrinkage / expansion. You maybe
required to use the provided spacers
and place a space of 2mm to ensure
every roof board lines up with the
truss’.
*Ensure the roof boards meet at the
top of the apex and leave an
overhang at the bottom.
Continue adding the roof boards
along the roof, fixing each one into
position using 3x40mm screws,
making sure that each board is
interlocked, flush at the bottom &
meet at the top of the apex.
The last board on each side
will overhang: Using a straight edge
and a pencil mark out a line as a
guide.
Cut along the pencil mark and
remove the excess. Place the cut
down board’s back onto the roof and
secure into place using 3x40mm
screws per board.
*Please Note:
This image is for
illustrative purposes and may differ
from your choice in product. Never-
theless the process of cutting and
fitting the last roof boards is the
same.
216x40mm Screws
40mm
screw
Pre drill
hole
*Cut to fit
Step 11
Parts needed - No. 19 QTY 4
Ensuring the roof boards are
flush at the overhanging side
and meet at the apex, fix the
Eaves Frames (
No. 19
) to the
underside of the roof boards
using 9x40mm screws as shown
in the illustration.
*Please Note:
This image is for
illustrative purposes and may
differ from your choice in
product. Nevertheless the process
of fixing the eaves frames is the
same.
36x40mm Screws
40mm
screw
Pre drill
hole
a
b
a
b