P 12
Please retain product label and instructions for future reference
23
Pre drill
hole
70mm
screw
Step 17
Parts needed - No. 23 QTY 2
Align the Roof Purlins (
No.
23
) into the cut out slots on the
gable top ensuring they interlock.
Secure the roof purlins at
each end by screwing through the
purlins into the gable below, and
through the purlin into the Log
cabins purlin, as illustrated, using
2x70mm screws per end.
*Please note:
The gable shown is for
illustrative purposes and may differ in
width from your choice in product.
Nevertheless, despite any differences
the process of fixing the purlins is the
same.
8x70mm Screws
a
b
a
IMPORTANT:
Pre-drill before fixing screws.
23
b
IMPORTANT:
Pre-drill before fixing screws.
Rubber Mallet
may be required
to fit parts.
40mm
screw
Pre drill
hole
*
Cut to fit
Step 18
Parts needed - No. 27 QTY 11
Place the remaining roof board from
the Log Cabin onto the roof. Fix in place to
the Purlin, front and back of the cabin,
using 3x40mm screws.
Place the first roof board (
No. 27
) onto the
shed add on, making sure the boards are
flush to the end of the roof purlin. Ensure
there is an even amount of overhang
between the log boards and roof board at
the front and back of the cabin. Once in
position fix to the purlins, front and back of
the shed add on using 3x40mm screws.
Ensure the roof boards are not laid too
close together, use the spacers (
No. 35
)
provided to create a 2mm gap. Adjusting
the spacing between the boards allows
the wood to swell in damp weather.
Continue to add roof boards onto the roof.
Once in position fix to the purlin, front and
back of the log cabin using 4x40mm srews
per roof board.
You have been issued with 11 roof boards,
but in reality you may only need to use 10.
*Please note: the roof boards on the shed
add on will sit short of the roof boards on
the log cabin
The last board will overhang onto
the log cabin. Using a straight edge and a
pencil, mark out a line as a guide.
Cut along the pencil mark and remove the
excess. Place the cut down board’s back
onto the roof and secure into place using
4x40mm screws per board.
*Please Note:
This image is for illustrative
purposes and may differ from your choice in
product. Nevertheless the process of cutting
and fitting the last roof board(s) is the same.
48x40mm Screws
a
a
b
27
b
