Mercia Garden Products 03DTSHCR0909FGD4TW-V1, General Instructions Manual

Page: 7 / 10

P 7
Please retain product label and instructions for future reference
Step 18
Parts needed - No. 17 QTY 2
- No. 25 QTY 2
Fit the Cover Trims (No.17) to the back
of the building onto the joins of the
panels, secure using 3x30mm screws
per cover trim.
Fix the rear cover trims
(No.25)
to the
back of the building, aligning with
the edge of the panel.
12x30mm Screws
30mm
screw Pre drill
hole
25
25
17 17
Cut four strips from the roll of
felt
(No.30):
2 x 430cm (L) X 100cm (W)
1 x 350cm (L) X 100cm (W)
1 x 150cm (L) X 100cm (W)
Place the felt on top of the roof
and align as shown in diagram
ensuring each strip overlaps
the next by 20cm. Ensure all
strips over hang roof by 5cm.
Ensure strip 1 is the first piece
placed down then lay sheet 2, 3
and then 4 on top.
Cut the sides as shown in
diagram at the dotted lines, use
fascia width as guide for
overhang.
Fix each sheet using felt tacks
along where sheet overlap.
Use felt tacks at 100mm
intervals.
200x Felt Tacks
Step 16
HANDLE
WITH CARE
1
2
3
4
100cm
20cm
20cm
20cm
5c
m
5c
m
5c
m
430cm
350cm
150cm
1
2
3
4
5c
m
30
30
30
30
Please note: It is advisable to place a board across the length of
the roof to kneel on whilst felting.
Felt
tacks
**If Shed add on Pack has been purchased,
please move onto the Add on Pack Instructions**
Step 17
Parts needed - No. 16 QTY 4
Fit the Cover Trims
(No.16)
to the front
of the building onto the joins of the
panels, secure using 3x30mm screws
per cover trim.
12x30mm Screws
30mm
screw Pre drill
hole
16
16
16
16