P 7
Please retain product label and instructions for future reference
Step 14
To assemble the Ladder, slot each Ladder
Step
(No. 44)
into the grooves of the
Ladder Sides
(No. 42
&
No. 43)
and
fix using 2x40mm screws on each end.
20x40mm Screws
40mm
screw
Pre drill
hole
Step 15
Place the Ladder inbetween the rail
support and plain panel, fix in place using
4x40mm screws.
Secure 1x40mm screw at an angle through
the Ladder side into the floor. Place another
40mm screw to fix the opporsite side to
the vertical framing of the plain panel as
shown in the diagram
6x40mm Screws
40mm
screw
Pre drill
hole
Step 16
The next step is to fit the Ladder Hand Rails.
First attach the Right Hand Rail
(No. 39)
to
the Rear Panel using 4 x 50mm screws, pre drill
holes first and make sure the screws are
fixed into the Rear Panel framing .
Next fix the Left Hand Rail
(No. 40)
to the side
of the Bunk Floor Safety Rail using 2x 50mm
screws, make sure to pre-drill holes first.
Then attach one of the Hand Rail Supports
(No. 41)
to the bottom of the ladder and
Left Hand Rail using 3x 50mm screws. Fix the
Hand Rail Support to the floor with a 70mm
screw, make sure this screw goes down into the
floor joist running below.
Fix the remaining hand rail support to the
ladder and left hand rail using 3 x50mm
screws, midway between the top and
bottom.
12x50mm Screws
1x70mm Screws
50mm
screw
Pre drill
hole
70mm
screw
44
42
43
39
40
41
