11
Mercedes-Benz Wallbox Home
| Preparations, installation and taking into operation
DANGER!
Always observe the 5 golden rules of electrical installation:
1. Cut off all voltage sources
2. Secure all cut-off devices
3. Verify absence of voltage
4. Ground and short-circuit
5. Cover or bar access to adjacent components under voltage
Always deactivate the MCB in the domestic power supply as well as the internal RCCB before starting installation. Also
ensure that the MCB and RCCB cannot be reactivated during installation. Otherwise, there is a risk of severe or even fatal
injury through electric shock!
Proceed as follows to install the Wallbox:
1. Ensure that a sufficiently dimensioned power supply cable is available at the desired installation site. Otherwise, a power
supply cable must be installed especially.
2. Place the drilling template vertically onto the chosen mounting surface:
Use a spirit level if required. Mark the drill holes using the template.
3. Drill the mounting holes as marked (Ø 8 mm). Depending on the substrate,
insert the wall plugs supplied for the mounting screws.
4. Use the TX30 screwdriver to insert two of the four 6 x 60 chipboard
screws included into the two upper drill holes and tighten to a distance of
4 mm from the wall.
5. Place the Wallbox onto a work surface and open the lockable screw at
the lower edge of the housing base using the housing cover key provided.
Then flip the housing cover up and remove it.
Note:
Protect the housing cover from scratches and other types of exter-
nal damage. Only remove the protective film from the housing cover as
your last step, immediately before completing installation.
