Vehicle care
197
!
Make sure the combination switch is set
to wiper setting
0. Otherwise, the rain
sensor could activate and cause the wipers
to move unintentionally. This may lead to
vehicle damage.
Due to the width of the vehicle, fold in
exterior rear view mirrors prior to running
the vehicle through an automatic car wash
to prevent damage to the mirrors.
When leaving the automatic car wash, make
sure the mirrors are folded out.
After running the vehicle through an
automatic car wash, wipe any wax off of the
windshield and the wiper blade inserts. This
will prevent smears and reduce wiping noise
which can be caused by residual wax on the
windshield.
X
For regular cleaning and care of ornamental
moldings, use a damp cloth.
!
Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings
may have chrome appearance, they could
be made of anodized aluminum that will be
damaged when cleaned with chrome
cleaner. Instead, use a damp cloth to clean
those ornamental moldings.
For very dirty ornamental moldings of
which you are sure are chrome-plated, use
a chrome cleaner. If in doubt whether an
ornamental molding is chrome-plated,
contact an authorized Mercedes-Benz
Center.
Headlamps, brake lamps, tail lamps,
side markers, turn signal lenses
X
Use a mild vehicle wash detergent, such as
Mercedes-Benz approved Car Shampoo,
with plenty of water.
!
Only use window cleaning solutions that
are suitable for plastic lamp lenses.
Window cleaning solutions which are not
suitable may damage the plastic lamp
lenses of the headlamps. Therefore, do not
use abrasives, solvents or cleaners that
contain solvents.
Cleaning the windows and the wiper
!
The windshield wipers must be in a
vertical position before folding them away
from the windshield. They could otherwise
damage the hood.
Never open the hood when the wiper arms
are folded forward.
X
Make sure the hood is fully closed.
X
Switch on the ignition.
X
Turn combination switch to wiper setting
II (
X
With wiper arms in vertical position, switch
off the ignition.
For safety reasons, switch off wipers and
remove SmartKey from starter switch
(KEYLESS-GO: Make sure the vehicle’s on-
board electronics have status
0) before
cleaning the windshield and/or the wiper
blades. Otherwise, the wiper motor could
suddenly turn on and cause injury.
!
Do not pull on the wiper blade inserts.
They could tear.
X
Fold the wiper arms forward until they snap
into place.
X
Clean the windshield and the wiper blade
inserts with a clean cloth and mild
detergent solution.
X
Use a soft, clean cloth and a mild window
cleaning solution on all outside and inside
glass surfaces.
An automotive glass cleaner is
recommended.
Operation
230_AKB; 1; 42, en-US
d2ureepe,
Version: 2.11.7.1
2008-11-27T15:37:19+01:00 - Seite 197
Z
