Opening/closing the roof
158
X
Hook boot separator
1
into the fastening
eyelets in the side panels.
X
Fully close the zipper (
Y
page 156).
X
Fold back the material covering of the zip-
per along the whole length of the boot
separator if necessary.
Draught stop
The draught stop is a wind protection device
for driving with the soft top open. It is stored
in a bag or sheath in the boot*.
G
Risk of accident
Fold back the top part of the draught stop
if it restricts your vision or when it is dark.
It could otherwise impair your rear view.
and you could cause an accident.
Fitting
X
Take the draught stop out of the bag.
X
Leave the draught stop folded and place it
on the roll-over bar.
1
Lateral guide
X
Push the draught stop into the roll-over bar
on both sides as far as it will go, so that both
lateral guides
1
reach under the roll-over
bar. Make sure that the fastening straps are
not trapped.
X
Put up the roll-over bar (
Y
page 46) so far
that you can easily reach under it.
2
Buckle
X
Route the fastening straps around the top
of the roll-over bar and close buckle
2
.
X
Tighten the straps if necessary.
X
Fold down the roll-over bar again.
X
Fold the top part of the draught stop in the
direction of the head restraints as far as it
will go.
Removing
X
Fold back the top part of the draught stop.
X
Put up the roll-over bar (
Y
page 46) so far
that you can easily reach under it.
Controls
* optional
230_AKB; 5; 4, en-GB
bjanott,
Version: 2.9.6
2008-04-08T15:09:54+02:00 - Seite 158
Dateiname: 6515_3089_02_buchblock.pdf;
preflight