The battery must be connected and charged.
Otherwise, you:
R
cannot turn the SmartKey to position 2 in the
ignition lock
R
cannot release the electric parking brake
R
cannot shift the automatic transmission to
position N
Disarm the automatic locking feature before the
vehicle is towed (
Y
page 84). You could other-
wise be locked out when pushing or towing the
vehicle.
If the vehicle is in a dangerous area, it can be
towed out of that area with both axles on the
ground. In this case, the towing distance must
not be greater than 165 ft (50 m) and must not
exceed a towing speed of 6 mph (10 km/h). For
longer distances, have the vehicle loaded and
transported.
Installing/removing the towing eye
Installing the towing eye
G
WARNING
The exhaust tail pipe may be very hot. There is
a risk of burns when removing the rear cover.
Do not touch the exhaust pipe. Take particular
care when removing the rear cover.
The brackets for the screw-in towing eye are
located in the bumpers. They are at the rear and
at the front, under covers
:
.
X
Remove the towing eye from the vehicle tool
kit or the stowage tray (
Y
page 327).
X
Press the mark on cover
:
inwards in the
direction of the arrow.
X
Remove cover
:
from the opening.
X
Screw in the towing eye clockwise as far as it
will go and tighten it.
Removing the towing eye
X
Unscrew and remove the towing eye.
X
Attach cover
:
to the bumper and press until
it engages.
X
Place the towing eye in the vehicle tool kit or
the stowage tray.
Towing a vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
(
Y
page 338).
The automatic transmission automatically shifts
to position P when you open the driver's or front-
passenger door or when you remove the Smart-
Key from the ignition lock.
In order to ensure that the automatic transmis-
sion stays in position N when towing the vehicle,
you must observe the following points:
X
You must use the SmartKey instead of the
Start/Stop button (
Y
page 145).
X
Make sure that the vehicle is stationary and
that the key is in position 0 in the ignition lock.
X
Turn the SmartKey to position 2 in the ignition
lock.
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to position
N.
X
Release the brake pedal.
X
Release the electric parking brake.
X
Leave the SmartKey in position 2 in the igni-
tion lock.
X
Switch on the hazard warning lamps
(
Y
page 126).
In order to signal a change of direction when
towing the vehicle with the hazard warning
lamps switched on, use the combination switch
as usual. In this case, only the indicator lamps
for the direction of travel flash. After resetting
Towing and tow-starting
339
Br
eakd
own
assistance
Z
