Mercedes-Benz R 350 2012, Operator'S Manual

Page: 300 / 368

X
Turn retaining screw
:
counter-clockwise
and out of tool holder
=
and remove it.
i If retaining screw
:
does not come out
immediately, turn tool holder
=
slightly
counter-clockwise.
Retaining screw
:
can then be unscrewed
with ease.
X
Turn tool holder
=
approximately 180°, so
that the tire inflation compressor points
backwards.
X
Remove tool holder
=
from collapsible
spare wheel
;
.
X
Remove collapsible spare wheel
;
from
the emergency spare wheel well.
For further information on changing a wheel
and mounting the spare wheel, see
(
Y
page 299).
Stowing a used collapsible spare wheel
Take the following steps to stow a used
collapsible spare wheel. It will otherwise not
fit in the spare wheel well. Mercedes-Benz
recommends that you have this work carried
out at a qualified specialist workshop, e.g. an
authorized Mercedes-Benz Center.
!
Only place the collapsible spare wheel in
the vehicle when it is dry. Otherwise,
moisture may get into the vehicle.
X
Unscrew the valve cap from the valve.
X If possible, unscrew the valve insert from
the valve and release the air.
i Fully deflating the tire can take a few
minutes.
X
Screw the valve insert back into the valve.
X
Screw the valve cap back on.
In the spare wheel well, there are two
guides
:
to keep the collapsible spare wheel
in place.
X
Lay collapsible spare wheel
;
in the
emergency spare wheel well.
i
Make sure that collapsible spare
wheel
;
is positioned on guides
:
precisely.
X Lay the tool holder in collapsible spare
wheel
;
so that the electric air pump is
pointing towards the tailgate (
Y
page 296).
X Turn the tool holder approximately 180°,
so that the electric air pump points
forwards.
The tool holder should now be positioned
in accordance with the instructions on the
installation position.
X Turn the retainer screw on the collapsible
spare wheel clockwise into the tool holder
as far as it will go.
X
Stow the jack in the vehicle tool kit.
298
Where will I find...?
Breakdown assistance