Mercedes-Benz G 550 2015, Operator'S Manual

Page: 226 / 274

tion switch, the hazard warning lamp starts
flashing again.
X
Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 103).
X
When the vehicle is stationary, depress the
brake pedal and keep it depressed.
X
Shift the transfer case to neutral position
N (
Y
page 134).
X
Shift the automatic transmission to posi-
tion N .
X
Release the brake pedal.
X
Release the parking brake (
Y
page 111).
i
The transmission can only change gear if
the battery has sufficient charge.
If you cannot move the selector lever to
N ,
the propeller shafts to the driven axles
must be removed.
Transporting the vehicle
!
You may only secure the vehicle by the
wheels, not by parts of the vehicle such as
axle or steering components. Otherwise,
the vehicle could be damaged.
Use the towing eyes to pull the vehicle if it
needs to be transported on a trailer or trans-
porter (
Y
page 223).
X
Apply the parking brake.
X
Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 103).
X
Shift the selector lever to N .
X
Shift the transfer case to neutral
(
Y
page 134).
X
Secure the towing cable to the towing eyes
(
Y
page 223).
X
Make sure that the vehicle cannot roll
away.
X
Release the parking brake.
X
Load the vehicle onto the transporter.
As soon as the vehicle has been loaded:
X
Apply the parking brake.
X
Shift the automatic transmission to posi-
tion P .
X
Turn the SmartKey to position 0 in the igni-
tion lock (
Y
page 103) and remove it.
X
Secure the vehicle.
Recovering a vehicle that has become
stuck
!
When recovering a vehicle that has
become stuck, pull it as smoothly and
evenly as possible. Excessive tractive
power could damage the vehicles.
If the drive wheels have become stuck in
loose or muddy ground, pull the vehicle out
with extreme caution, especially so if the vehi-
cle is loaded.
Never attempt to recover a stuck vehicle with
a trailer attached.
Pull out the vehicle backwards, if possible
using the tracks it made when it became
stuck.
Towing in the event of malfunctions
General notes
!
If you are removing the propeller shaft,
use M10 nuts as spacers on the M8 bolts
and secure them with M8 nuts.
New self-locking nuts must be used when
the propeller shafts are refitted.
X
Observe the safety notes as you do so
(
Y
page 222).
i
Consult an authorized Mercedes-Benz
Center.
224
Towing and tow-starting
Roa
dsi
de
Assi
st
an
ce