Mercedes-Benz EQA 2021, Owner'S Manual, Page: 187 / 457

#
Press and hold button 1 , 2 or 3 that you
wish to program.
Indicator lamp 4 ashes yellow.
%
It can take up to 20 seconds before the indi-
cator lamp ashes yellow.
#
Release the previously pressed button.
Indicator lamp 4 continues to ash yellow.
#
Point remote control 5 from a distance of
1 cm to 8 cm towards button 1 , 2 or 3 .
#
Press and hold button 6 of remote control
5 until one of the following signals appears:
R
Indicator lamp 4 lights up green continu-
ously. Programming is complete.
R
Indicator lamp 4 ashes green. Program-
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
#
If indicator lamp 4 does not light up or ash
green: repeat the procedure.
#
Release all of the buttons.
% The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
Sync Synchr hronising t onising the r he rolling code olling code
RReq equir uirements: ements:
R
The door system uses a rolling code.
R
The vehicle must be within range of the garage
door or door drive.
R
The vehicle as well as persons and objects are
located outside the range of movement of the
door.
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
#
Press previously programmed button 1 , 2
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
%
Please also read the operating instructions for
the door drive.
TTrroubleshoo oubleshooting when pr ting when progr ogramming t amming the r he remote emote
contr control ol
#
Check if the transmitter frequency of remote
control 5 is supported.
#
Replace the batteries in remote control 5 .
#
Hold remote control 5 at various angles from
a distance of 1 cm to 8 cm front of the inside
rearview mirror. You should test every position
for at least 25 seconds before trying another
position.
184 184 Driving and parking