When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is to
synchronize the rolling code (
Y
page 254).
X
Release button
B
on remote control
A
for
the garage door drive system.
If indicator lamp
:
lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door opener
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least
25 seconds before trying another position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(
Y
page 253).
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you will
need to use the programming button on the door
drive control panel. The programming button
may be located in different places depending on
the manufacturer. It is usually located on the
door drive unit on the garage ceiling.
Familiarize yourself with the garage door drive
operating instructions, e.g. under "Program-
ming additional remote controls", before carry-
ing out the following steps.
Your vehicle must be within reach of the garage
door or gate opener drive. Make sure that nei-
ther your vehicle nor any persons/objects are
present within the sweep of the door or gate.
X
Turn the SmartKey to position 2 in the ignition
lock (
Y
page 128).
X
Get out of the vehicle.
X
Press the programming button on the door
drive unit.
Usually, you now have 30 seconds to initiate
the next step.
X
Get into the vehicle.
X
Press previously programmed button
;
,
=
or
?
on the integrated garage door opener
repeatedly and in quick succession until the
door closes.
The rolling code synchronization is then com-
plete.
Notes on programming the remote con-
trol
Canadian radio frequency laws require a "break"
(or interruption) of the transmission signals
after broadcasting for a few seconds. Therefore,
these signals may not last long enough for the
integrated garage door opener. The signal is not
recognized during programming. Comparable
with Canadian law, some U.S. garage door open-
ers also feature a "break".
Proceed as follows:
R
if you live in Canada
R
if you have difficulties programming the
garage door opener (regardless of where you
live) when using the programming steps
X
Press and hold one of buttons
;
to
?
on the
integrated garage door opener.
After a short time, indicator lamp
:
lights up
yellow.
X
Release the button.
Indicator lamp
:
flashes yellow.
X
Press button
B
of garage door remote con-
trol
A
for two seconds, then release it for two
seconds.
X
Press button
B
again for two seconds.
X
Repeat this sequence on button
B
of remote
control
A
until indicator lamp
:
lights up
green.
When indicator lamp
:
lights up green: pro-
gramming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is to
synchronize the rolling code.
X
Release button
B
of remote control
A
of the
garage door drive.
If indicator lamp
:
lights up red: repeat the
programming process for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door opener
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least
25 seconds before trying another position.
254
Features
Stowage
and
features
Summary of Contents for E-Class Cabriolet 2016
Page 321: ...319 ...
Page 322: ...320 ...
