Mercedes-Benz C 250 Coupe, Operator'S Manual

Page: 263 / 336

Calibrating the compass
X
Make sure that there is sufficient space for
you to drive in a circle without impeding the
remaining traffic.
In order to calibrate the compass correctly,
observe the following points:
R
calibrate the compass in the open and not
in the vicinity of steel constructions or high-
voltage transmission lines.
R
switch off electrical consumers, for
example, the climate control, windshield
wipers or rear window defroster.
R
close all doors and the trunk lid.
X
Switch the ignition on.
X
Press a round pin into opening
=
(
Y
page 260) for approximately six seconds
until the
C
symbol appears in compass
display
;
(
Y
page 260).
X
Drive a full circle at approximately 3 mph
(5 km/h) to 6 mph (10 km/h).
Once the calibration has been successfully
completed, the current direction appears in
compass display
;
(
Y
page 260).
Floormat on the driver's side
G
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
X
Slide the seat backwards.
X
To install: place the floormat in the
footwell.
X
Press studs
:
onto retainers
;
.
X
To remove: pull the floormat off
retainers
;
.
X
Remove the floormat.
Features
261
Stowing and features
Z