D.
Installation of the Completed Bracket Assembly
1.
Place the completed bracket assembly near
the installation point (Figure 4).
2.
Connect the 25-pole
D
-connector from the
telephone
Y
-cable to the vehicle harness.
3.
Connect the 15-pole
D
-connector from the
vehicle harness to the optional VRM (if so
equipped).
Note:
Be sure to read the application specific
D2B notes on page 1 of this bulletin for
information on the fiber optics to be used for the
installed configuration.
4.
Connect the fiber pair labeled
TEL
to the PSE
optical cavity.
5.
If installing the optional voice recognition
system, connect the fiber pair labeled
SBS
to
the VRM. Leave the pair labeled
TEL/SBS
capped and off to the side if not installing the
voice recognition system.
Figure 4
P82.70-2932-01
6.
Connect the 90º mini-UHF connector from the
front center console to the linear compensator
RF jack labeled
Portable
.
7.
Connect the remaining RF lead, from the
integrated bumper antenna, to the linear
compensator RF jack labeled
Antenna
.
8.
Seat the bracket in the quarter panel cavity and
fasten it with three (3) M6 flange nuts.
9.
Route all cables neatly around the control units
and bracket assembly (Figure 5).
Note:
Fiber optic cables must be handled with
care, free of kinks, bends, and abrasions.
Figure 5
P82.70-2933-01
© 2005 Mercedes-Benz USA, LLC
