Problems when programming
Integrated remote control in the rear-view mirror
:
Indicator lamp
;=?
Transmitter buttons
A
Garage door remote control
B
Transmitter button on the garage
door remote control
If you have problems when programming the
integrated remote control, please note the
following:
R
Check the transmitter frequency of garage
door remote control
A
(which can usually
be found on the back of the remote
control).
The integrated remote control is
compatible with devices that have units
which operate in the frequency range of
280 to 390 MHz.
R
Replace the batteries in garage door
remote control
A
. This increases the
probability of garage door remote control
A
sending a strong and more precise
signal to the integrated remote control on
the rear-view mirror.
R
When programming, hold garage door
remote control
A
at varying distances and
angles from the transmitter button which
you are programming. Try various angles at
a distance between 2and 12 inches (5to
30 cm) or at the same angle but at varying
distances.
R
If there is another garage door remote
control for the same device, perform the
programming steps again using that garage
door opener. Before performing these
steps, make sure that new batteries have
been inserted in the garage door remote
control.
R
Align the antenna cable of the garage door
opener unit. This can improve signal
reception/transmission.
Opening/closing the garage door
:
Indicator lamp
;=?
Transmitter buttons
A
Garage door remote control
B
Transmitter button on the garage
door remote control
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
read the operating instructions for the garage
door system.
X
Turn the SmartKey to position
2(
Y
page 97) in the ignition lock.
X
Press transmitter button
;
,
=
or
?
on
the integrated remote control in the rear-
view mirror that is programmed to operate
the garage door.
Garage door system with fixed code:
indicator lamp
:
lights up continuously.
Garage door system with rolling code:
indicator lamp
:
flashes briefly and then
lights up for approximately two seconds.
This is repeated for up to 20 seconds.
i
The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. The transmission will be halted
Features
197
Stowage
and
features
Z
