Mercedes-Benz 2009 CLK-Class, Operator'S Manual

Page: 106 / 384

Power windows
104
where you pulled the switch past the
resistance point and released it to close the
window, the automatic reversal function
will stop the window and open it slightly.
If a door window encounters an obstruction
that blocks its path in a circumstance
where you are closing the window by pulling
and holding the switch, by pressing and
holding button
j
on the SmartKey, by
pressing and holding the lock button
(vehicles with KEYLESS-GO) on an outside
door handle, or CLK cabriolet: by operating
the soft top switch, the automatic reversal
function will not operate.
Activate the override switch when children
are riding in the back seats of the vehicle.
The children may otherwise injure
themselves, e.g. by becoming trapped in
the door window opening.
G
Observe Safety notes, see
page 58.
G
Warning!
If you pull and hold the switch up when
closing the door window, and upward
movement of the door window is blocked
by some obstruction including but not
limited to arms, hands, fingers, etc., the
automatic reversal will not operate.
i You can also open or close the windows
using the SmartKey, see “Summer opening
feature” (
Y
page 105) and “Convenience
closing feature” (
Y
page 106).
i After switching off the ignition or
removing the SmartKey from the starter
switch, you can operate the windows until
you open a door. If no door was opened you
can operate the windows for up to
5 minutes.
1
Left door window
2
Right door window
3
Right rear side window
4
Left rear side window
X
Switch on the ignition.
X
Opening/Closing: Press or pull and hold
switch
1
to
4
to the resistance point.
The corresponding window will move
downwards or upwards until you release
the switch.
X
Express operation: Press or pull switch
1
or
2
past the resistance point and
release.
The corresponding door window opens or
closes completely.
X
Stopping during express operation:
Press or pull the respective switch again.
! If the upward movement of a door window
is blocked during the closing procedure,
the door window will stop and open slightly.
Remove the obstruction, pull the
respective power window switch again past
the resistance point and release.
If the door window still does not close when
there is no obstruction, pull and hold the
respective power window switch. The door
window will then close without the
obstruction sensor function.
G
Warning!
Driver’s door only: If within 5 seconds the
switch is again pulled past the resistance
Controls in detail