Flat tire
361
Preparing the vehicle
X
Park the vehicle in a safe distance from
moving traffic on a hard, flat surface when
possible.
X
Turn on the hazard warning flasher.
X
Turn the steering wheel so that the front
wheels are in a straight-ahead position.
X
Engage the parking brake.
X
Shift the automatic transmission into park
position
P (manual transmission to 1st or
reverse gear
R).
X
Turn off the engine.
X
Remove the SmartKey from the starter
switch.
or
X
Vehicles with KEYLESS-GO: Open the
driver’s door (this puts the starter switch in
position
0, same as with the SmartKey
removed from the starter switch). The
driver’s door can then be closed again.
Open doors only when conditions are safe
to do so.
X
Vehicles with KEYLESS-GO: Remove the
KEYLESS-GO start/stop button from the
starter switch.
X
Have any passenger exit the vehicle at a
safe distance from the roadway. Open
doors only when conditions are safe to do
so.
Mounting the spare wheel
Introduction
X
Prepare the vehicle as described
(
Y
page 361).
X
Take the following out of the vehicle:
R
spare wheel
R
jack
R
vehicle tool kit box
For information on where to find the
respective items, see “Where will I
find ...?” (
Y
page 302) and (
Y
page 304).
Lifting the vehicle
G
Warning!
When jacking up the vehicle, only use the
jack which has been specifically approved
by Mercedes-Benz for your vehicle.
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. Make
sure the jack arm is fully seated in the jack
take-up bracket. The jack must always be
vertical when in use, especially on inclines
or declines.
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle. To help avoid personal
injury, use the jack only to lift the vehicle
during a wheel change.
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.
Always firmly set the parking brake and
block the wheels with wheel chocks or
other sizeable objects before raising the
vehicle with the jack. Do not disengage the
parking brake while the vehicle is raised.
Make sure that the ground on which the
vehicle is standing and where you place the
jack is solid, level and not slippery. If
necessary, use a large underlay. On
slippery surfaces, such as tiled floors, you
should use a non-slip underlay, for example
a rubber mat.
Do not use wooden blocks or similar
objects to support the jack. Otherwise the
Practical hints
Z
Summary of Contents for 2009 C 230
