Mercedes-Benz 2008 C 300 4MATIC Sport, Operator'S Manual

Page: 386 / 406

X
To remove: take socket ; and lug wrench
= from the vehicle tool kit (
Y
page 340).
X
Position socket ; on hub cap : .
X
Attach lug wrench = to socket ; and
loosen hub cap : counter-clockwise.
X
Remove hub cap : .
X
To install: before installing, check hub
cap : and the wheel area for soiling and
clean if necessary.
X
Put hub cap : in position and turn until it is
in the right position.
X
Position socket ; on hub cap : .
X
Attach lug wrench = to socket ; and
tighten hub cap : .
The tightening torque must be
18 lb-ft (25 Nm).
i
Note that the hub cap should be tight-
ened to the specified torque of 18 lb-ft
(25 Nm). Mercedes-Benz recommends
that you have the hub cap installed at a
qualified specialist workshop.
X
Using a lug wrench = , loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
The jacking points are located just behind the
front wheel housings and just in front of the
rear wheel housings (arrows).
Vehicles with AMG equipment: the vehicle
has covers installed to protect the vehicle
body next to the jacking points on the outer
sills.
X
Vehicles with AMG equipment: fold
cover ? upwards.
X
Position jack B at jacking point A .
384
Changing a wheel
Whe
el
s
and
tire
s