Point ID Extended Format
This is a new format which is used to send
additional fast format data to the alarm receiver.
The additional information can be used to
indicate the circuit that caused the alarm, the user
that set/unset the system etc. For the DC58M+ to
send this additional data, the unit must be
plugged on to a Menvier control panel that
supports "Point ID Extended Format"' and report to
a compatible alarm receiver.
Modem
When a call is made to the alarm site the DC58M+
will pick up the call and attempt to connect to the
modem that is connected to the P.C. If successful
the communication link is established and data
can be transferred. When the Modem is on-line
the red LED on the DC58M+ flashes continuously
until the communication link is broken. If during the
Modem operation the control panel generates an
alarm which is required to be transmitted to the
ARC, the DC58M+ will suspend the Modem
operation and attempt to communicate with the
alarm receiver.
Installation
A LED 1
Activity LED. On whilst communicator is active.
Flashes on and off 4 times when successfully
communicated with the ARC. Flashes
continuously when modem is in operation.
B Test Call
Short these two pins to initiate a test call.
C NVM
Removable Non-Volatile Memory used to store
all programmed data.
D JP2 (SELV)
Connector for Menvier control panels.
E JP1 (SELV)
Connector to NETLCD/TS900 remote keypad
(Programmer).
F Telephone Connections (TNV)
Terminal connections to the telephone line.
G HI/LO SECURITY
Line fault monitoring level:
Link fitted = High Security
Link removed = Low Security
Plug-on Installation
1.
Isolate ALL power from the control panel
(battery and mains).
2.
Do not attempt to continue if the mains or
battery supply is still present.
3.
Remove the cover from the DC58M+ case
and if appropriate fit a pre-programmed NVM.
4.
Connect the interface lead to the control
panel connector (DIGI MODEM) via the cable
entry hole in the base, then connect the lead
onto JP2 on the DC58M+ (marked TO
CONTROL PANEL).
6
Installation
DC58M+ Installation Instructions
A
A1
B
B1
NVM
TEST
CALL
TS900
REMOTE
A
E
B
C
D
F
G
HI/LO SECURITY
TO
CONTROL
PANEL
JP 2
JP 2
Figure 3
DC58M+ PCB Layout
