4-7
PROGRAMMING
Preprogrammed Number Pads
Oven has 10~20 preprogrammed number pads. Follow
instructions below to program heating times and power
levels for customized cooking.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
“PROGRAM” indicating program mode.
3. Press desired number pad.
• Display shows heating time, “COOK LEVEL” and
power level if other than 100 percent power.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds, press
2, 3, and 0 pads.
5. Press desired power level pad to change power level.
• If a power level pad is not pressed, oven defaults to
100% power.
• For example, pressing MEDIUM 50% pad sets oven to
50% power.
• Display shows current power level if other than 100%
power.
6. Press START pad to save new heating time and power
level in oven memory.
• Repeat step 3-6 to program additional pads.
7. Press RESET pad or close oven door to exit
programming mode.
Multiple Heating Stages
Follow instructions below to program oven to perform 3
consecutive heating cycles without interruption.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds.
3. Press desired number pad.
• Display shows heating time and preprogrammed
number.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
5. Press desired power level pad to change power
level.
• If a power level pad is not pressed, oven defaults to
100% power.
• For example, pressing MEDIUM 50% pad sets
oven to 50% power.
• Display shows current power level if other than 100
percent power.
6. Press TIME ENTRY pad.
• Display briefly shows "STAGE 2" . Then cook time
and power level for stage show in display.
• Repeat steps 5-6 to create additional stages.
7. Press START pad to save new heating time and
power level in oven memory.
8. Press RESET pad or close oven door to exit
programming mode.
Summary of Contents for DECS11MA
