Mendota GREENBRIAR M-50, Installation & Operating Instruction Manual

Page: 59 / 68

- 59 -
TAB #2
USE LARGE PLIERS TO
BEND DOWN (4) TABS
AS SHOWN
GLASS
GASKET
GLASS FRAME ASSEMBLY REPAIR AND REPLACEMENT
TO REPLACE DAMAGED GLASS
1. Bend Glass Retainer Tabs ( Figure 45 ) up 90 degrees. Four tabs hold down the glass and gasket assembly.
2. Remove the damaged glass and gasket material. Clean the inner surface of the glass frame.
3. Assemble new gasket on glass edge starting with the bottom left corner. The adhesive on the gasket should
make contact with the glass surface. Use tracer lines in gasket to determine where the glass should sit on the
gasket surface. See
Figure 45
.
4. Place glass and gasket assembly in glass frame and carefully bend down glass retainer tabs. Extra glass retainer
tabs are provided should any originally used tabs break off.
The glass frame assembly and its individual components are available
through Johnson Gas Appliance Company. Contact your dealer for more
detailed ordering information.
GLASS FRAME ASSEMBLY # HA-48-00103
REPLACEMENT PARTS LIST
ITEM PART NUMBER DESCRIPTION
1 HA-52-00003
FRAME, WELDMENT, GLASS,
M50
2 65-02-00103
GASKET, TADPOLE,
3/8”BULB, 3/4” TAIL
3 65-06-01063 GLASS, CERAMIC, M50
Figure 45
WARNING
Do not operate this appliance
with the glass removed, cracked
or broken. Glass should be re-
place by a licensed or qualified
person.
WARNING
Use only authorized parts and
materials obtained from Johnson
Gas Appliance Company when
replacing defective or damaged
glass.
DO NOT substitute other manufac-
turer's materials or components.
DO NOT operate unit with cracked,
broken or missing glass.
DO NOT abuse the glass door by
striking the glass, slamming the
door shut, etc
GLASS
TRACER LINES
IN GASKET
GLASS SHALL SIT BETWEEN
TRACER LINES IN GASKET
ROTATE GASKET UP
SO ADHESIVE MAKES
CONTACT WITH GLASS
SURFACE
ADHESIVE
GASKET
GASK
ET
IN
FL
AT
FORM
Figure
Figure 44