Mendip Stoves Ashcott, Operation And Installation Manual

Page: 5 / 32

5 OF 32
MINIMUM DISTANCE TO NON-COMBUSTIBLE MATERIALS
The stove can be recessed in a suitable sized non - combus�ble fireplace but a permanent free air gap of at least 50mm must
be le� around the sides and top and at least 50mm at the back of the stove to obtain reasonable heat output and for access to
the stove for removal and maintenance. A clearance of 100mm will give a be�er heat output.
All non - combus�ble walls closer than 100mm to the stove should be at least 75mm thick. For prac�cal reasons the back wall
of the fireplace recess and the hearth should ideally be made of non -combus�ble material. When installing a your stove in a
non combus�ble chamber combus�ble materials should not be located where the heat dissipa�ng through the walls of
fireplaces or flues could ignite it. Therefore when installing the stove in the presence of combus�ble materials due account must
be taken of the guidance on the separa�on of combus�ble material given in Building Regula�ons Approved Document J and also
in these stove instruc�ons. The minimum distances to flammable materials are specified on the EN 13240 plate on the back of
the stove
STOVE DIMENSIONS AND CONNECTION MEASUREMENTS
Height Width Depth
Depth inc.
Direct Air
Intake
Collar
Size
Distance from
Air Intake
Diameter
Rear to
Centre
Flue Collar
Floor to
Rear Flue
Exit
Floor to Air
Intake
Stove
A B C C* D E F G H
ASHCOTT 575mm 424mm 310mm 412mm 125mm 128mm 460mm 151mm 100mm
ASHCOTT
PEDESTAL
750mm 424mm 370mm 412mm 125mm 128mm 635mm 326mm 100mm
ASHCOTT
LOGSTORE
800mm 424mm 370mm 412mm 125mm 128mm 685mm 376mm 100mm