20NM50-00 E2
2016-05-17
Page 5
Technical Data
Security
-
WEP 64 and 128 bit
-
WPA/WPA2 Personal and Enterprise
General Protocols
-
Proxy ARP, DNS, HTTP, HTTPS, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, PPPoE,
DHCP
AP Protocols
-
ARP, BOOTP, DHCP, STP/RSTP (IEEE 802.1D/w)
Routing
-
Optional feature when Cellular upstream option is selected
-
Static and dynamic routing, IPv46 IPv6, TCP/IP, UDP, ICMP, STP, RSTP, MSTP, RIPv1,
RIPv2, RIPng
Remote monitoring and maintenance via Ethernet and WLAN
Local monitoring and maintenance via USB device port (Model: 09NM50-01)
Software initiated restart
Watchdog
Connectivity
USB host at front for mass storage (Model: 09NM50-01)
USB device for maintenance (Model: 09NM50-01)
WiFi Network
-
Up to two WiFi 802.11b/g/n/ac modems (UC-Option)
-
2x2 MIMO supported
-
Optional antenna diversity for each radio
-
Maximum data rate 300 Mbit/s (n); 54 Mbit/s (g), 11 Mbit/s (b)
-
Both 2.4GHz and 5GHz supported (depending on configuration)
-
Unlimited parallel users; Bandwidth-limited to 60 per WiFi RF interface
Cellular Network (Available on request only)
-
3.5G/4G modem (UC-Option)
Discrete I/O (Model: 09NM50-01)
Opto-isolated output (open collector) user programmable status output
-
Reports device status to external devices
-
Freely programmable via Web browers or console I/F
-
Report sevice error signal/flag to host option
Opto-isolated output user programmable input
-
Freely programmable via Web browers or console I/F
-
Report external device status to Access Point option
-
Report 'engine off' in bus applicaion option
One dedicated W_Disable input
-
Active low signal to disable RF operation
-
Direct disable of radio operation on either WLAN or cellular cards
Discrete input levels
-
Input current for high:
-
Input current for low: <1 mA
-
Input switching level: 40 to ±5%
Independent input reference voltage range 0 to 154 V
Optocoupler shutter control option
Only available on the NM50 version with full configuration
