AT2550 User Guide
December 8, 2003
page 5 of 17
3.1.4 MOUNTING
The AT2550 may be mounted in any orientation. Eight mounting holes are
available: four on the bottom and four on the sides. All holes are threaded 3mm,
with a maximum penetration of 4mm.
The diagram given below is for a 4.8 Gbyte drive. Drives with higher capacities
will be 12.5mm or taller. All other dimensions remain identical.
3.1.5 COMPUTER SETUP
To be recognized by the computer, the drive translation information must typically
be entered into the System Setup or CMOS Setup utility. For non-PC compatible
computers, this may not apply. The AT2550 supports automatic configuration if
offered by the BIOS. Automatic CHS translation and LBA mode is also supported.
