Use conventional stranded copper wire for all connections. Tinned Copper Memphis marine grade wire is
recommended for corrosion resistance in powersports and marine applications. Finish the ends of the wires at the
amp and vehicle with proper size terminals. Poorly made connections and/or inadequate wire size will generate
excessive heat and may lead to equipment failure.
12 Volt + Connection
make the 12V+ connection directly at the positive battery post using the proper wire size and fuse listed below, The
fuse should be installed within 18” of the battery for standard applications and withing 7” of the battery for marine
applications*. This fuse is vital to protecting the vehicle from damage in the case of a dead short. The fuse value at
the battery should be at least equal to the total fuse value of all the amplifiers being used.
Ground Connection:
For marine applications connect the ground to the negative battery terminal. For non-marine applications ground
connection directly to the chassis of the vehicle as close to the amp as possible. Make sure this connection is made
with the same wire size as used for the 12 volt connection. Ensure that all dirt, grease, paint and coatings are
removed prior to attaching the ground wire to chassis.
Remote Turn On
Remote turn on should be connected to the source unit’s remote turn on lead. 18 gauge wire should be ran from
the remote turn on lead on your source unit to the terminal labeled REM on your amplifier.
MME10TSP POWERED ENCLOSURE ONLY!
POWER CONNECTIONS
ONLY APPLY TO MME10TSP
AMPLIFIED ENCLOSURES
Install the fuse at the battery last!
TO SOURCE UNIT’S
REMOTE TURN-ON LEAD
FUSE HOLDER
(18” FROM BATTERY)
GROUND DIRECTLY TO BATTERY
FOR MARINE APPLICATIONS
*NOTE: Seven inches is the standard distance under U.S. Coast Guard CFR33 for placement of fuses or
breakers as required by law for new boat manufacturing. It is recommended that you adhere to this standard
in an installation. Not adhering to this regulation puts the safety of boat passengers at risk in the event of a
power wire shirt circuit.
