•
If your Fog Machine fails to work properly, discontinue use immediately.
Drain all fog liquid from the tank, pack the unit securely (preferably in the
original packing material), and return for service.
•
Always drain tank before mailing or transporting this unit.
•
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog
liquid comes in contact with skin or eyes, rinse thoroughly with water.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the
system has arrived intact. If any equipment is missing contact your dealer immediately.
Before beginning initial setup of your Fog Machine, make sure that there is no evident
damage caused by transportation. In the event that the unit’s housing or cable is
damaged, do not plug it in and do not attempt to use it until after
contacting your dealer for assistance.
Setup & Operation
•
Remove all packing materials from shipping box. Check that all foam and
plastic padding is removed, especially in the nozzle area.
•
Place Fog Machine on a flat surface and remove fog liquid tank cap.
•
Fill with high-quality water-based fog fluid. Any other types of fluid can
damage the unit. When filled, place cap back on liquid tank..
•
Plug power cord into a grounded electrical outlet.
•
The indicator light in Activation Switch Control will light up. This indicates the
machine is warming up.
•
When the indicator light in the Activation Switch Control goes OFF after 4 minutes,
the foggy is ready for use.
•
Press switch on the Activation Switch Control to release the fog. The button should
be depressed for as long as fog is required. The maximum continuous burst is one
minute.
•
At times, the indicator light in the Activation Switch Control will light up. This is
NORMAL, the Fog Machine is simply recycling.
You fog machine may be installed at floor level or suspended overhead and do not allow
the unit to have more that a 15 degree angle of inclination.
Important : Always monitor tank fluid level as you are fogging. Running a fog machine
with no fluid can permanently damage the unit.
If you experience low output, pump noise or no output at all, unplug
immediately. Check fluid level, the external fuse, remote connection, and
power from the wall. If all of the above appears to be O.K., plug the unit in
again. If fog does not come out after holding the FOG button down for 30
seconds, check the hose attached to the tank to make sure there is fluid going
through the hose. If you are unable to determine the cause of the problem, do
not simply continue pushing the remote button, as this may damage the unit.
Return the machine to your dealer for repair.
