Requires and assistant:
Before placing the cooking components into your
grill, insure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box (stainless
steel mechanism found at the front between each
set of Burners.) The easiest way to insure this is
to perform this Electrode Check:
16
1. Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2. Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
3. Push in Control Knob and turn counter clock-
wise until (IGN) is visible. Push Control Knob
in. You should hear a clicking sound and your
assistant should see a small blue spark within
each Gas Collector Box. If a spark is present
the Electrode Tips are properly positioned.
4. If no spark is seen the Spark Gap shown in
Figure 15
needs to be adjusted as follows:
•
Using an adjustable wrench, loosen the inside
Nut just until the Gas Collector Box can be
maneuvered and turned upward.
•
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
•
If the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas
Collector Box until the gap is correct.
•
Return the Gas Collector Box to its original
horizontal position, secure the inside Nut and
try
the Electrode Check again.
5. If no "clicking" sound is heard check the
following common causes.
If you need
assistance call our Grill Information Center
at 1-800-770-9769.
•
Ignitor AA battery not installed properly.
•
Ignitor wires may be loose. Remove the AA
battery, inspect the Ignitor Junction Box
found behind the Control Panel, and connect
any loose wires.
Ignitor Battery Installation - See Figure 14
1. Unscrew the Ignitor Cap located on the Grill Control
Panel and remove the Contact and Spring from the
Ignitor Slot.
2. Place the manufacturer supplied AA battery into the
Ignitor Slot. Be sure to place the positive pole facing
toward you.
3. Place the Spring over the AA battery, then place
the Contact on top of the Spring. Screw the Ignitor
Cap back onto the grill Control Panel.
Grill Information Center:
If you have questions about assembly or grill operation, or if there are damaged
or missing parts when you unpack this unit from the shipping boxes, call us 8am - 4:30 pm CST, Monday
through Friday at:
1- 800-770-9769
+
_
Electrode Check
Figure 14
IGNITOR SOLT
CONTRACT
SPRING
AA BATTERY
IGNITOR CAP
Figure 15 - Side View Gas Collector Box
INSIDE
NUT
SPARK
ELECTRODE TIP
SPARK GAP