than three successive blasts.
•
The spray button has to be pressed repeat-
edly to release the first spray.
Vertical steaming
It is possible to iron hanging curtains, items of
clothing on a hanger, etc. To do so, follow the
instructions:
•
Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction.(Fig 2)
•
Move the iron in a top to bottom direction while
pressing the steam control ( B ). Important: for
cotton and linen, its recommended to put the
iron base in contact with the material.
•
For other more delicate fibres, it’s recom-
mended to keep the iron base a few centime-
tres away.
Once you have finished using the appliance:
•
Select the minimum position (MIN) using the
thermostat control.
•
Unplug the appliance to the mains.
•
Remove the water from the water tank.
•
Clean the appliance
Cleaning
•
Disconnect the appliance from the mains and
let it cool before undertaking any cleaning
task.
•
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
•
Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
•
Do not submerge the appliance in water or
any other liquid, or place it under a running
tap.
Self-cleaning function:
•
It is important to self-clean the appliance at
least once a month to remove calcium and
any other built-up minerals inside the iron.
•
Fill the depository to its maximum level, as in-
dicated on “water fill” section.
•
Place the iron in a vertical position, plug in to
the mains and select the maximum tempera-
ture.
•
Leave the appliance to heat up until the pi-
lot light indicates that it has reached its con-
signed temperature.
•
Unplug the appliance and place in the sink.
•
Press the self-clean button, and keep it
pressed down.
•
Let the water flow out through the steam vents
in the base, while lightly shaking the appli-
ance.
•
Release the button after a minute or when the
tank becomes empty.
•
Leave the iron in the vertical position until it
has cooled.
Anomalies and repair
•
Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair without assistance, as this
may be dangerous.
•
If the connection to the mains has been dam-
aged, it must be replaced and you should pro-
ceed as you would in the case of damage.
23260_IM.indd 5
2013/08/26 10:06:48 AM
