PROFESSIONAL HAIR CLIPPER
INSTRUCTION MANUAL
READ ALL INSTRUCTIONS BEFORE USING
AND STORE FOR SAFEKEEPING.
BLADE ALIGNMENT
• Your clippers were carefully examined to
ensure that the blades were oiled and aligned
before leaving the factory.
• Blades must be realigned if they have been
removed for cleaning or replacement.
• To realign the blades, each upper blade tip
should be in line with the corresponding
lower blade tip.
(The bottom blade’s teeth tips should be
approximately 1.2mm below the top blade’s teeth
tips.)
• If blade alignment is incorrect, add a few drops
of oil to the blades, switch on clipper for a few
seconds, switch off and unplug. Loosen screws
slightly and adjust. Tighten screws after blade
is aligned.
• To change blade, use Phillips screw driver to
loosen 2 screws.
• Remove blade and replace with new blade.
• Align top blade then place bottom blade over
top blade and insert screws and tighten slightly.
• Align bottom blade as explained in “BLADE
ALIGNMENT” & tighten screws further to secure
bottom blade in place.
OIL
• To keep your clipper in peak condition, the
blades should be oiled every few uses.
• Do not use hair oil, grease, oil mixed with
kerosene or any other solvent. The solvent
will evaporate and leave a thick layer of oil
which may slow down the blade’s motion.
1.2mm
Part Name
ACCESSORIES
Blade lever
On/off switch
Bottom blade
Top blade
Comb
Scissors
Oil
Brush
Attachment Comb #1
Attachment Comb #3
Blade Cover
Attachment Comb #4
Extra Blade
Attachment Comb #2
20800_IM.indd 2
2013/03/05 10:32:08 AM
