Information about the Lamp:
Assembly VisorLite I:
Mellert SLT GmbH & Co. KG
⋅⋅⋅⋅
D-75015 Bretten / Germany - Fax +49 (0)7252 / 505 - 10
⋅⋅⋅⋅
www.mellert-slt.com
Assembly:
Set the tilted back lamp
fixture centred at the
inner edge of the sight
holder, incline to the front
until the holder snaps in.
(Fig.1.1). Lead the spring
of the sight holder (incl.
rubber protection) through
the clips of the battery
compartment, mind the
installation true to side!
(Fig.1.2). Refit as usual
the sight holder incl. fas-
tened lamp fixture and
battery compartment at
the helmet.
Dismantling:
For dismantling, press in
the centre inside of the
lamp fixture – the fixture is
released, tilts automatically
backwards and can easily
be removed.
Fig. 1.1
Fig. 1.2
Fig. 1.3
Lighting functions:
2 x LED
Nahbereich
3 x LED
Fernbereich
5 x LED
Nah- Fernbereich
OFF
3 x LR 06 - 1,5 V
included
Fig. 2.1
Fig. 2.2
Fig. 2.3
Assembly VisorLite II:
Slide in the lamp with fixture into
the collet at the helmet until it
snaps in. (Fig.2.1).
Loosen then the rear plastic screw at the
helmet, push then the battery compartment
with the bent over clip from below on the
helmet until the boreholes are aligned.
Tighten again the plastic screw with care..
(Fig.2.2).
Slide on the battery compartment with the
lateral recess on one side at the corre-
sponding clip until the end, insert then the
second clip in the second recess on the
other side until the boreholes of the fixture
are aligned with those of the battery com-
partment. Tighten steadily the screws pro-
vided to this aim. (Fig.2.3).
