![background image](http://html1.mh-extra.com/html/hds-systems/action-light-iii/action-light-iii_user-manual_2112558001.webp)
Action Light™ III Headlamp User’s Guide
Copyright 2003-2004 by HDS Systems, Inc.
All rights reserved
March 3, 2005
Introduction
The Action Light III headlamp is your best-of-class headlamp that provides a regulated
light output at a user-selected brightness. Matching the amount of light to the task will
maximize battery life - yet can still provide an intensely bright light when you need it.
A single button activates your light and easily selects the desired brightness.
The following illustration summarizes the available commands and will assist you in
quickly learning to use your flashlight. However, please read the full User’s Guide so
you will fully understand how each feature works.
Installing the Battery
Unlock the 6 side latches, remove the back cover, remove the old batteries from the
battery compartment, insert the new batteries into the battery compartment with the
negative end toward the spring, replace the back cover and lock the 6 side latches.
Note: you will know it is time to replace the battery when your light blinks down two
brightness levels - that is, your light momentarily turns off and then turns back on two
brightness levels lower, repeating as needed until your light finds a brightness level that
the battery can handle.
Note: you should perform a soft reset when changing battery chemistries. This will
ensure the new battery configuration is properly detected.