18
19
18
19
KEY TO MAIN COMPONENTS OF THE
APPLIANCE
1. Motor section
2. Drive shaft
3. Safety lock
4. Lock pins for plastic bowl
5. Suction cup feet
6. On/Off button
7. Cord with plug
8. Lid for blender function
9. Safety lock pin
10. Plastic bowl
11. Blade for blender function
12. Tamper
13. Lid for grater function
14. Grater attachment
15. Attachment holder pin
16. Attachment holder
17. Blade (grate/slice function)
18. Blade (grate/shred function)
19. Drive shaft port
20. Filling port
21. Spout
PRIOR TO FIRST USE
• Read through the safety instructions
carefully.
• Before using for the first time, or after
prolonged storage without use, wash
any parts that will come into contact
with food.
USING THE APPARATUS
1. Place the motor section (1) on a flat
surface, e.g. a kitchen counter, and
make sure it stands firmly on the four
suction cup feet (5) underneath.
2. Place the plastic bowl (10) down onto
the drive shaft of the motor section (2),
so that the drive shaft fits into the port
(19).
o Make sure that the two parts fit
together properly. There should be
no gap between the bottom of the
bowl and the motor section.
o Turn the plastic bowl
counterclockwise so that the lock
pins (4) click into place and hold
it fast.
3. Fit the selected blender or grater
function components as described
below.
Use of blender function
1. Make sure that
the On/Off
button (6) is
set to “0” (off).
2. Mount the
blender
function blade
(11) onto the
drive shaft in
the middle
of the plastic
bowl. Make
sure that it is
pressed down as far as it will go.
3. Add foodstuffs to the bowl – only fill the
bowl approximately two-thirds full.
4. Place the lid (8) on the appliance, and
turn counterclockwise, so that the pin
(9) clicks into place in the safety lock
(3).
o Make sure that the lid fits tightly.
o NOTE: The safety lock ensures that
the appliance cannot be turned on
if the lid or the safety lock pins are
not fitted correctly.
5. Insert the plug (7) in the mains socket
and switch on the power.
6. Switch on the apparatus by switching
the on/off button to one of the following
settings:
o "CHOP" (lowest speed)
o "SLICE/SHRED" (highest speed)
o "GRIND" (the appliance only runs
as long as the On/Off button is held
at this setting).
7. Turn off the appliance by turning the
On/Off button to “o” and remove the
plug from the socket.
8. Wait until the blade has come to a
complete stock before removing the lid.
