Melissa 640-043, User Manual

Page: 15 / 27

- Do not use the appliance on wet
surfaces.
- Do not obstruct the air intake or the air
outlet vents.
- Do not use the appliance to vacuum
needles, drawing pins or string.
ASSEMBLING THE VACUUM CLEANER:
Always remove the plug from the power
socket before fitting or removing
accessories.
Fitting the tube:
- Press the buttons on the end of the
tube and insert the tube into the air-
intake.
REMOVING THE HOSE:
Remove the plug from the power socket. To
release the hose, press the buttons on the
end of the hose and pull the hose firmly from
the air intake duct.
FLOOR BRUSH USE
- Press the left button on the floor brush
down for cleaning hard floors.
- Press the rigth button on the floor brush
down for cleaning carpets.
INSTRUCTIONS FOR USE
- Before using the appliance, unwind a
sufficient length of cable and insert the
plug into the power socket. A yellow
mark on the power cable shows the
ideal cable length. Do not extend the
cable beyond the red mark.
- To rewind the power cable, press the
rewind button with one hand, and guide
the cable with the other hand to ensure
that it does not whip causing damage.
- Press the ON/OFF button to switch the
appliance on.
ADJUSTMENT OF THE TELESCOPIC
TUBE
You can adjust the lenght of the telescopic
tube by holding the black ring and pulling or
pushing the part with the locking mecanism.
It can be unlocked just as easily and
brought into a different position.
REPLACING THE DUSTBAG:
- Remove the hose.
- Lift the front cover and move the lock
that holds the dust bag forward. Now
the dust bag can be removed.
- Place a new dustbag and move the lock
back over the dustbag so it sits firm in
its place.
REPLACING THE MOTORFILTER
the motorfilter is the filter placed behind the
dustbag.
-
Take the filter holder out and remove the
filter.
- Clean the filterholder before a new filter
is placed in it.
- Push the filter holder with the new filter
back in place.
REPLACING THE MICROFILTER
The microfilter is the filter placed on the
back of the vacuum cleaner:
Press the release-button on the grid and
pull it out at the same time.
Remove the microfilter and insert a new
microfilter.
Insert the grid back in place.
15
IM 06/06/05 15:20 Side 15