20
2
20
2
Thinning with a comb attachment
Set the locking ring so the thinning symbol
is level with the arrow on the appliance.
Thin the hair or the beard by cutting
against the growth direction of the hair.
Tips
• Check the required comb attachment is
fitted and set to required length.
• Only cut small lengths of hair at a
time. Use decreasing settings until you
achieve the right length.
o The cutting head will slow down or
become blocked if the speed is
too fast or if you cut too much hair
at a time.
• Hold the appliance with the slanting
side of the comb attachment facing
the head, and move in slow, even
movements through the hair. If
necessary, use the scissors (4) and the
comb ().
• Brush the hair cuttings away from
the head as you go to see how you
progress.
• Regularly shake hair cuttings from the
appliance to prevent the cutting head
from becoming blocked.
Recharging the batteries
The appliance can be charged directly
using the adapter () supplied, or can be
charged in the holder.
• Connect the small jack at the end
the cord (2) to the charging socket
underneath the appliance (2) or to the
socket on the back of the holder () if
the appliance is placed in the holder.
• Plug in and switch the power on.
• Check the appliance is switched off
(on/off button at 0).
o The charging indicator () will show
red during charging. The indicator
does not switch off when charging
is complete but the appliance
switches off automatically, as it is
protected against overheating.
o Normal charging takes approx. 7
hours.
o The appliance can run for approx.
40 minutes when fully charged.
CLEANING AND MAINTENANCE
• Brush cutting head and comb
attachments using the small cleaning
brush (7) after each use.
• Lubricate the cutting head regularly
with 1-2 drops of the lubricating oil
supplied (6). See "Lubricating the
cutting head" below.
• Only wipe the appliance with a dry
cloth. Do not use water for cleaning the
appliance.
Lubricating the cutting head
• Detach the comb attachment and
carefully remove the cutting head by
pushing it backwards.
• Press the spring on the cutting head to
open it.
• Add 1-2 drops of oil, release the spring
to close the cutting head and move it
back and forth to distribute the oil.
• Press the cutting head back onto the
appliance until it clicks into place.
• Wipe off any excess oil with a cloth.
Caution!
Only use acid-free oil, e.g. sewing machine
oil, if the supplied oil runs out.
INFORMATION ON DISPOSAL AND
RECYCLING OF THIS PRODUCT
Please note that this Adexi product is
marked with this symbol:
This means that this product must not be
disposed of along with ordinary household
waste, as electrical and electronic waste
must be disposed of separately.
Summary of Contents for 638-144
Page 30: ...30...
