16
Make sure the AC power supply is fully inserted into the mains socket, and that the cable is correctly connected to the
DC IN connector of the transmitter.
• Make sure the connectors of the audio cable used (optical or analogue) are correctly connected to the pertinent
sockets.
• Make sure the batteries are charged, recharging them if necessary.
• If the audio feed has been connected using a digital optical cable (Toslink), check that the audio output of your
appliance (e.g. TV or decoder) is set to “PCM” or “LPCM”. To do this correctly, consult the instruction manual of your
TV or decoder.
• If the audio connection is made using a stereo audio jack cable, make sure the device connected plays back the audio
correctly (even with the cable disconnected), and check that the green light "
P
" on the base remains lit. If necessary,
increase the output volume on the device.
• Turn the wheel "C" on the headphones to adjust the sound to the desired level.
• Check you have not inadvertently activated environmental sound listening; if so, you can deactivate it by pressing the
“
MIC
” button (the light "
B
" must be green).
• The headphones (receiver) may be too far from the base (transmitter). Move closer to it.
If the headphones (receiver) are not PAIRED with the base (transmitter) – the green LED B must be flashing.
Pair as follows:
1. Make sure the base (transmitter) and the receiver (headphones) are both switched off, and that the headphones are
not inserted into the base.
2. Switch off the headphones (receiver).
3. Hold the MIC button down for about 5 seconds; the green LED B will flash quickly
4. Switch off the base (transmitter).
5. The headphones (receiver) and the base (transmitter) will pair automatically, and after a few seconds, the green LED
6. B of the headphones stops flashing and remains lit.
Troubleshooting
Help line
If you have any queries regarding HP STETO Digital:
• read this instruction manual carefully, as it will help you solve most problems.
• visit our website: www.meliconi.com
For any questions/problems, you can call our customer TECHNICAL ASSISTANCE on (+39) 02 66012766, or write to
us at [email protected]
Simplified EU Declaration of Conformity
The manufacturer, Meliconi S.p.A., declares that the type of radio equipment marketed as HP Steto Digital is compliant
with Directive 2014/53/EU (RED).
The full text of the EU Declaration of Conformity is available at the following web address:
http://www.meliconi.com/doc/hpstetodigital
Summary of Contents for HP STETO
Page 2: ...2 FRONT REAR H I C B D A E F G 7 8 1 2 4 5 1 2 4 3 6 3...
Page 23: ...21...
