14
Technical specifications
Transmission bandwidth:
UHF 863-865 MHz
Carrier frequencies:
863,3 MHz - 864,5 MHz (2 canales)
RF output Power:
<10mW e.r.p.
Frequency response:
60 Hz – 14 KHz stereo
Distortion:
<1 %
Signal/noise ratio:
≥ 70dB
Maximum transmission distance:
100 metres (in free field)
Headphone charging time:
about 2-2.5 hours
Integrated Lithium Polymer battery (headphones): 3,7V – 400mAh
Operating time of the headphones:
about 8 hours with a fully charged battery, at medium volume
Operating temperature:
0°C-40°C
Use
For normal use, simply turn the headphones on and off, exclusively by pushing button "
D
" positioned on
the headphones. NOTES: It is possible to use the headphones with a direct connection to the audio source
(without the base), by plugging the 3.5 mm jack cable into AUX socket "
E
".
If the headphones do not produce any sound or if the audio signal is disturbed or is presumed to come from
other sources, carry out the following steps:
1. Check that all the connections are correct and that the device is operating as described in this manual.
2. If the audio feed has been connected using a digital optical cable (Toslink), check that the audio output of
your appliance (e.g. TV or decoder) is set to “PCM” or “LPCM”. To do this correctly, consult the instruction
manual of your TV or decoder.
3. If the 3.5 mm jack cable has been used for the audio connection, make sure the device connected
plays the sound correctly (even with the cable disconnected), and check that the “L” light is lit blue. If
necessary, turn up the output volume on the device.
4. urn off the headphones with button "
D
", move closer to the base unit then turn the headphones on again,
checking if the green light "
C
" comes on.
5. If the problem persists, use the “
H
” switch on the base to try changing channels (A/B); Briefly press the
“
D
” button and make sure the base is paired correctly with the headset (“C” light green).
6. Use the “
A
and “
B
” buttons to adjust the audio on the headset.
Troubleshooting
Helpline
If you have any queries regarding HP Easy Digital:
• read this instruction manual carefully, as it will help you solve most problems.
• visit our website: www.meliconi.com
For any questions/problems, you can call our customer TECHNICAL ASSISTANCE on (+39) 02 66012766,
or write to us at [email protected]
Simplified EU declaration of conformity
The manufacturer, Meliconi S.p.A., declares that the type of radio equipment marketed as HP Easy Digital
Headphones is compliant with Directive 2014/53/EU (RED).
The full text of the EU Declaration of Conformity is available at the following web address:
http://www.meliconi.com/doc/cuffiahpeasydigital.
